Unable to change any filters for a tune.

Calibrations for FlashPro Manager - Use all calibrations at your own risk (dyno tuning recommended)

Post Reply
bjg0493
Posts: 1
Joined: Tue Feb 28, 2017 7:59 pm

Unable to change any filters for a tune.

Post by bjg0493 »

Hello all,
New to the forum. I am currently unable to change any parameter data, as far as mods, on the new calibration setup. I have not used my flashpro for 5 months due to no other modifications. I go to new calibration with the module connected to my laptop, opens up with the new calibrations tab and i have the correct vehicle selected. Where the filters tab is, I click it to display supporting modifications and nothing shows up. I am also unable to perform any function (ie. revert to stock, change tune....etc). I have also ensured that the most current software was up to date (2.6.2.0). Any input would be helpful. Thanks guys.
Attachments
Flashpro.bmp
Flashpro.bmp (3 MiB) Viewed 1119 times
User avatar
Spunkster
Site Admin
Posts: 22741
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: Unable to change any filters for a tune.

Post by Spunkster »

Download the software form the Software section of the website and when you install it make sure you install the calibrations for your vehicle.
Post Reply