Cpr no sync light
-
- Posts: 1
- Joined: Tue May 23, 2017 4:43 am
Cpr no sync light
If the dizzy when bad or something will I get a no sync light car has power n ign light flashes but no sync light shop has checked wiring 2 to 3 times n nothing is wrong please if I could get some help on this would be appriciated thanks I have a p28 v2 ecu with the latest software
Re: Cpr no sync light
Have all 3 options been checked for the CPR in the calibration?
Re: Cpr no sync light
Ive been wondering the same thing. I cant get mine to sync but it used to before...same ecu, same hondata cpr. trying to rule things out now
Re: Cpr no sync light
Have you tried the troubleshooting steps at: http://www.hondata.com/help/cpr/troubleshooting.htm
Re: Cpr no sync light
I have.... I'm just wondering if a bad distributor will cause sync problems....does it?
Re: Cpr no sync light
It could if one of the sensors is not picking up or sending the pulses correctly.
Are you sure Q37 is installed?
Are you sure Q37 is installed?
Re: Cpr no sync light
Yes, the resistor is there. I've looked 100% and it's ran before. Cars been sitting for awhile so just wondering if maybe the distributor is no good.
Re: Cpr no sync light
It is a possibility.
Re: Cpr no sync light
If I was to check voltage while cranking...what should I be reading at each pin out?
Re: Cpr no sync light
You cant check voltage as it is a pulse. You would need an oscilloscope to properly measure it.