- FlashPro firmware updated to version 121
- [2017 CRV] Added support for 5PA-C65 Canada
- [2016-2017 Turbo Civic] Added boost by gear limit table and added support for 5AW-T51 - Turkey, 5AG-S83 - Australia, 5AA-Y52 - Middle East
- [2016-2017 Turbo Civic - CVT] Added torque limit tables
- [FN2] Fixed active tuning tables not downloading
FlashPro Manager software
12 posts • Page 1 of 1
Changes from 184.108.40.206:
Dis you fixed anything elese related to active tuning? Today I enabled it again and needed to disable it because while deiving it creates lean spots in lower rpms, usually noticable after shifts 1-2 and 2-3. I was usign 2.8.2 version, just saw your update.
Then increase your delay after injector restart. Also decrease the change per tuning cycle. You can also alter the minimum throttle to keep it from tuning at very low rpm/load combinations where the o2 is not responding quickly.
Hi hondata. Do u still have v2.8.2 software. I need it coz I lost my laptop and now using new labtop I can't download my map in flashpro. I try today to install back the flashpro manager but it's already version 2.8.4. Please send me v 2.8.2 software. Thanks
I need to download my calibration from the flashpro to use some new features. I didnt keep the file for this calibration. If i want to get back the file from tuner need to pay usd150. Each time update i need to pay for $150 if i need the calibration. I need the 2.8.2 so i can put it in my vault store. So next time i can download and use the updated features with the calibration. Thanks again for replying me
You don't need the same version of FlashProManager to download a calibration from a FlashPro. Your tuner may not have stored the calibration on the FlashPro.