As the title suggests. I have a PRA ecu on my ep3 and it uses a narrowband lambda sensor from the factory. Can it be made to use a wideband lambda as its primary?
Thanks
Can PRA ecu use wideband as primary?
Re: Can PRA ecu use wideband as primary?
What version K-Pro do you have?
Re: Can PRA ecu use wideband as primary?
Yes it can be used to input a wideband signal to run closed loop.
http://www.hondata.com/help/kmanager/an ... b=wideband
This can only be done using a V4 K-Pro.
http://www.hondata.com/help/kmanager/an ... b=wideband
This can only be done using a V4 K-Pro.
Re: Can PRA ecu use wideband as primary?
Aa ok sweet. I already have my wideband on analogue 0 for datalogging but how do I change it over so the ecu uses this input for its lambda readings and to use closed loop?
Re: Can PRA ecu use wideband as primary?
You will see it in the closed loop tab of the parameters window.
Re: Can PRA ecu use wideband as primary?
Ok thanks 👌🏻