Thank you for your help. IT WORKS!
The Kcontrol now looks stable between 40 and 55% while driving.
I had to bump up the knock sensitivity around 3000rpm AND from 5000 up. I did that with VERY small increment, so it took me time.
the behavior seem this :
-> when Kcontrol MOVES UP ( even if it stays below 100% )
--- then ignition timing freeze.
--- then some pattern appears in fuelling ( it basically bumps up to a way too rich 11.5/1 AFR )
-> The drop in power is obvious in the car when this happens.
Now problem is solved the power is good ==> all the time. ( with a steady 13.5/1 AFR at WOT )
EDIT : no the problem was not solved, sometimes it worked, sometimes not.
suggest me a guideline please
Re: suggest me a guideline please
Last edited by alollini on Fri Mar 14, 2014 4:07 am, edited 1 time in total.
Team CR-Z Youtube Videos here => http://www.youtube.com/playlist?list=PL127E8C02C6B25D4B&feature=plcp
CR-Z GT White "Blue Inside"
CR-Z GT White "Blue Inside"
Re: suggest me a guideline please
ok, trying to get rid of this Kcontrol 100% problem and this ultra-rich behavior at higher rpm;
i tried lowering ignition timing, up to a point where i felt i lost power. so i stopped. still no go.
then i started lowering knock sensitivity (putting higher values) but i was so much way off!
then I tried this plot 2D :
X axis RPM
Y axis K.level
assuming the engine was working ok, then i made a new knock sensitivity curve, identical in low and high vtec and identical from column 6 to 10 and the shape of the curve is an envelope 1% superior to the highest engine noise at each rpm, afer a 2 hour normal various driving datalog.
the new curve has nothing in common with the old one.
it works !
the engine is making less retard, does never richen, and feel punchier and more repeatable/consistent.
K.control stabilize at 21% then never moves.
the Rich ++ behavior was only happening when value of K.control moves up (even by 1%).
I have good torque at all rpm (no hole).
i tried lowering ignition timing, up to a point where i felt i lost power. so i stopped. still no go.
then i started lowering knock sensitivity (putting higher values) but i was so much way off!
then I tried this plot 2D :
X axis RPM
Y axis K.level
assuming the engine was working ok, then i made a new knock sensitivity curve, identical in low and high vtec and identical from column 6 to 10 and the shape of the curve is an envelope 1% superior to the highest engine noise at each rpm, afer a 2 hour normal various driving datalog.
the new curve has nothing in common with the old one.
it works !
the engine is making less retard, does never richen, and feel punchier and more repeatable/consistent.
K.control stabilize at 21% then never moves.
the Rich ++ behavior was only happening when value of K.control moves up (even by 1%).
I have good torque at all rpm (no hole).
Team CR-Z Youtube Videos here => http://www.youtube.com/playlist?list=PL127E8C02C6B25D4B&feature=plcp
CR-Z GT White "Blue Inside"
CR-Z GT White "Blue Inside"