AP1S2000 at the orange wire step installing Traction control

Post Reply
manchild83
Posts: 4
Joined: Mon Jan 20, 2020 1:14 pm

AP1S2000 at the orange wire step installing Traction control

Post by manchild83 »

Anyone have a picture of the harness that I need to tap A30 on? I just want to make sure I am getting to the right harness. I have a Kpro v4 with serial number 40523 and traction control serial number 12586. I have every other wire connected and ready to go except I am not sure exactly what harness I need to get A30. Please post a picture, one that is obvious or I can post a picture and someone just circle the harness or point me to the page in the service manual.
User avatar
Spunkster
Site Admin
Posts: 21225
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: AP1S2000 at the orange wire step installing Traction control

Post by Spunkster »

It is the A connector of the ECU and you must count from the top row from left to right then go to the next row and continue counting and so on.
manchild83
Posts: 4
Joined: Mon Jan 20, 2020 1:14 pm

Re: AP1S2000 at the orange wire step installing Traction control

Post by manchild83 »

Thank you I believe I have I believe I found the right wire. First harness, directly connected to the ECU, closest to the hood release latch. I also have to switch my O2 sensor from the one connected to the ELD over to the wide-band connected to my Analog 0. I believe I have covered now in my settings and all I have to do is have my orange wire on the A30 pin and my .tcc loaded.

Are you planning on releasing a Kpro firmware that supports the traction control connected to one of the on board analog inputs?
User avatar
Spunkster
Site Admin
Posts: 21225
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: AP1S2000 at the orange wire step installing Traction control

Post by Spunkster »

No there will be no update like that.
manchild83
Posts: 4
Joined: Mon Jan 20, 2020 1:14 pm

Re: AP1S2000 at the orange wire step installing Traction control

Post by manchild83 »

That's too bad. Thank you for all the advice. I will finish up everything when I have a moment away from work this weekend.
Post Reply