H22a4 stock basemap

Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
Post Reply
HondaBoi2001
Posts: 3
Joined: Sun Feb 20, 2022 2:22 pm

H22a4 stock basemap

Post by HondaBoi2001 »

Setup the calibration to match your ecu! Use at your own risk!

Before going to the dyno I wanted to shakedown the car. However It's really difficult to find a basemap for a stock engine on here. The calibrations available from hondata suck, so here is mine. (Street tuned with an AEM wideband) I will NOT include the dyno tuned map, but the car made 197.5whp@6400 171.4lbft@5000 fyi.

STOCK H22A4
STOCK intake manifold with secondary intake valves retained
STOCK Throttle body
STOCK exhaust manifold
STOCK 290cc Injectors
AEM cold air intake
Skunk2 Megapower with silencer
9lb racing flywheel
unsprung organic disc
Euro-R trans

Car made the same torque down low as a H23 built head, but lost huge above 5000rpm. Takeaway was the intake and manifold were too restrictive and I ran out of injector. If you want to use this basemap with a Euro R or skunk2 manifold, #1 adjust for injectors, #2 add 10-15% fuel below 4500 rpm and 5-10% above 6500rpm.
Attachments
290ccStockH22a4.skl
(49.8 KiB) Downloaded 44 times
HondaBoi2001
Posts: 3
Joined: Sun Feb 20, 2022 2:22 pm

Re: H22a4 stock basemap

Post by HondaBoi2001 »

I've made several corrections to my basemap, so please only download the newest version. Upload to follow
HondaBoi2001
Posts: 3
Joined: Sun Feb 20, 2022 2:22 pm

Re: H22a4 stock basemap

Post by HondaBoi2001 »

Calibration is with p28 s300 v3 (no IAB control). Ideal to have a P72 or follow HAMotorsports instructions for wiring/programming.
Attachments
290ccStockH22a4(REVISION).skl
(43.27 KiB) Downloaded 2 times
Post Reply