|
The S300 needs to output a synchronization signal to the coil driver. To do this follow these steps:
| • | Start SManager and load your calibration. |
| • | Open the Parameters Window. |
| • | Check the 'SYNC output on ALTC' option.
 |
| • | Upload your calibration to the ECU. |
The ignition dwell time for coil on plugs is typically the same or slightly higher than that for a distributor, so in most cases the dwell time settings can be left unchanged. Be aware that if the dwell time is increased the coil packs will run hotter, so it is not recommended to increase the dwell time.
|