• Accessories



    Hondata Methanol Tuning adapter cable

    Hondata Methanol Tuning adapter cable

    This cable adapts the AEM 30-3300 methanol injection system kit (sold separately) to your vehicle to allow FlashPro tuning of fuel and ignition. The installation and tuning procedure is in the help file. The power you make depends on your engine build and tuning. These dynos were made on stock engines with conservative tunes and 91 octane. Available for Hondata FlashPros supporting Flex Fuel / ethanol       Civic Si 06 +      Civic 1.5     Civic Type R      Accord 2.0     S2000 AP2     2.0 Civic Type R turbo 1.5 Civic Si turbo 1.5 Base Civic turbo   This product is for off-road and race only.

    $100.00
    Hondata 1.5 Turbo Denso Fuel System

    Hondata 1.5 Turbo Denso Fuel System

    *Now available for the 11th Gen 2022 Civic SI* The Hondata fuel system for the Honda L15B turbo 10th Gen Civic Si (2017-2021) consists of hardware and FlashPro Manager Software components designed to deliver significantly more fuel flow over stock (35% Injector, 39% cam/pump combo). This system enables your 1.5L turbo Honda Civic Si to take the next logical step for a reliable, well engineered and thoroughly tested fuel delivery solution. The Hondata 1.5L fuel system hardware paired with our proprietary software delivers fuel for those of you who have modifications that are limited by the stock fuel system. Although the camshaft does not make HP, it plays a key role in allowing you to use your FlashPro to tune for maximum power without the loss of fuel pressure. So if you’re ready to fuel more power or you’re simply tired of blending and would like the ability to run full E85 with your flex fuel kit, the Hondata Fuel System Upgrade is right for you. The Kit Includes: Installation instructions High Flow Fuel Injectors & Clips High Flow High Pressure Fuel Line Injector Fly Leads Camshaft FlashPro software includes the mod for injector and camshaft support Download FlashPro Manager 4.06 for the Hondata 1.5 Fuel System support. *Unlock codes are single-use only. If you need to use it again, a new purchase is required on our website.*     This kit is an OEM direct replacement, meaning everything can be returned to stock. Tuning is very simple with your FlashPro device. Apply the fuel system mod to your calibration and tune for boost, fuel and ignition as normal. If you do not have tuning experience we recommend contacting one of our many Authorized Dealers. Hondata has tested this system for a 300 hp increase over stock to well over 500 hp. Make your 1.5 Civic a Type R beater!     The Civic Si was upgraded with: Hondata FlashPro Hondata 1.5 fuel system Hondata 4 bar MAP sensors Garrett G25 turbo Custom Saenz rods JE pistons Darton sleeves C16 race gasoline    

    $2,600.00
    Hondata 4 bar MAP Sensor (B-Series)

    Hondata 4 bar MAP Sensor (B-Series)

    The Hondata 4 bar MAP sensor is a plug compatible replacement for the Honda factory MAP sensor. It is a direct replacement for the B, D, H, F-series, 00-05 S2000 engines. This plug in sensor takes less than 60 seconds to install and eliminates the risk of sensor damage that often occurs when attempting to wire in other types of MAP sensors. Important note for automatic transmissions Automatic transmission computers for the B, D, H, F-series, 00-05 S2000 share the MAP signal with the fuel injection computer.  If you have an automatic transmission and change the MAP sensor, then the AT computer will not work correctly.  You must retain the stock MAP sensor with ATs. How do I configure my software for the 4 Bar sensor? SManager & KManager - the settings are found in the 'Parameters' window under 'MAP'. FlashPro - in the 'Calibration' window under 'Sensors'.

    $99.00
    Hondata 4 bar MAP Sensor (K-Series)

    Hondata 4 bar MAP Sensor (K-Series)

    The Hondata 4 bar MAP sensor is a plug compatible replacement for the Honda factory MAP sensor. It is a direct replacement for the 02-06 RSX, 06-11 Civic Si, 04-08 TSX, 07-08 Fit, 04-08 TL, 03-07 Accord engines. This plug in sensor takes less than 60 seconds to install and eliminates the risk of sensor damage that often occurs when attempting to wire in other types of MAP sensors. Important note for automatic transmissions Automatic transmission computers for the 02-06 RSX, 06-11 Civic Si, 04-08 TSX, 07-08 Fit, 04-08 TL, 03-07 Accord share the MAP signal with the fuel injection computer.  If you have an automatic transmission and change the MAP sensor, then the AT computer will not work correctly.  You must retain the stock MAP sensor with ATs. How do I configure my software for the 4 Bar sensor? SManager & KManager - the settings are found in the 'Parameters' window under 'MAP'. FlashPro - in the 'Calibration' window under 'Sensors'.

    $99.00
    Hondata 4 bar MAP Sensor (S2000/R18/L15BCivic Si)

    Hondata 4 bar MAP Sensor (S2000/R18/L15BCivic Si)

    The Hondata 4 bar MAP sensor is a plug compatible replacement for the Honda factory MAP sensor. It is a direct replacement for the 06-09 S2000, R18, 2012+ SI, 2013+ ILX, 09-10 TSX, CRZ engines. This plug in sensor takes less than 60 seconds to install and eliminates the risk of sensor damage that often occurs when attempting to wire in other types of MAP sensors. The 1.5 Turbo Civic Si requires two of these sensors. Important note for automatic transmissions Automatic transmission computers for the 06-09 S2000, R18, 2012+ SI, 2013+ ILX, 09-10 TSX, CRZ share the MAP signal with the fuel injection computer.  If you have an automatic transmission and change the MAP sensor, then the AT computer will not work correctly.  You must retain the stock MAP sensor with ATs. How do I configure my software for the 4 Bar sensor? SManager & KManager - the settings are found in the 'Parameters' window under 'MAP'. FlashPro - in the 'Calibration' window under 'Sensors'.

    $99.00
    Hondata 7 bar MAP Sensor (B-Series)

    Hondata 7 bar MAP Sensor (B-Series)

    The Hondata 7 bar MAP sensor is a plug compatible replacement for the Honda factory MAP sensor. It is a direct replacement for the B, D, H, F, J and K-series Honda engines. This plug in sensor takes less than 60 seconds to install and eliminates the risk of sensor damage that often occurs when attempting to wire in other types of MAP sensors. How do I configure my software for the 7 Bar sensor? SManager & KManager - the settings are found in the 'Parameters' window under 'MAP'. FlashPro - in the 'Calibration' window under 'Sensors'.

    $125.00
    Hondata 7 bar MAP Sensor (K-Series)

    Hondata 7 bar MAP Sensor (K-Series)

    The Hondata 7 bar MAP sensor is a plug compatible replacement for the Honda factory MAP sensor. It is a direct replacement for the B, D, H, F, J and K-series Honda engines. This plug in sensor takes less than 60 seconds to install and eliminates the risk of sensor damage that often occurs when attempting to wire in other types of MAP sensors. Important note for automatic transmissions Automatic transmission computers for the 2009-2010 TSX, 2006-2011 R18 Civic, any CVT CRZ, Asian RRH based Civics share the MAP signal with the fuel injection computer.  If you have an automatic transmission and change the MAP sensor then the AT computer will not work correctly.  You must retain the stock MAP sensor with ATs. How do I configure my software for the 7 Bar sensor? SManager & KManager - the settings are found in the 'Parameters' window under 'MAP'. FlashPro - in the 'Calibration' window under 'Sensors'.

    $125.00
    Hondata Analog cable

    Hondata Analog cable

    Replacement analog cable used in the S300v2 (red board), S300V3 (white board), KPro3 (red board) and KPro4 (white board).  Also used for the digital cable for the S300V3 and KPro4 (for the S300V3 cut the cable down to 8 positions). The cable uses a 10 position 0.1" spacing square pin connector with 12" wire.

    $10.00
    Hondata Boost Control Components

    Hondata Boost Control Components

    Components necessary for your OBDI ECU to run a boost control solenoid.  Kit includes Q20, Q28, D14, R70 & R71 components, instructions and ECU pins for both OBDI and OBDII ECUs.

    $10.00
    Hondata Boost Control Solenoid

    Hondata Boost Control Solenoid

    The Hondata 4 port boost controller precisely directs pressure to the top and bottom of your waste-gate diaphragm. It allows much lower waste-gate spring pressure for better low gear boost control and perfect high gear, high boost control. A 10 lb waste-gate spring will enable 50+ psi of boost Better spool-up and mid range power Better duty cycle control For use with: S300 K-Pro FlashPro 2006-11 Civic Si FlashPro S2000 FlashPro 07/08 TSX The Hondata 4 port boost control solenoid is designed for use in high boost applications, but also works well in low boost applications. It is normally closed so that on failure you will run off the waste-gate spring to prevent over-boosting.  It uses 1/8th NPT fittings which can be adapted to AN fittings. If you are upgrading from a 3 port solenoid, the boost control tables will need re-tuning.

    $100.00
    Hondata CPR harness

    Hondata CPR harness

    Replacement harness for the CPR.

    $150.00
    Hondata CPR Pin Kit

    Hondata CPR Pin Kit

    Hondata CPR (Coil Pack Retrofit) Pin Kit

    $25.00
    Hondata CTR MAF 500

    Hondata CTR MAF 500

    The Hondata MAF 500 sensor replaces your Civic Type R (FK2/FK8) MAF sensor to increase the CTR MAF air metering range from 300 g/s to 500 g/s. With a stock MAF sensor you will reach the maximum range with a stock turbo, airbox and bolt-ons. When this happens the fueling becomes inaccurate. The Hondata CTR MAF 500 accurately measures 60% more air with the stock airbox, which allows you to tune up to around 640 hp. Installation involves unplugging the stock sensor and re-using the same two phillips screws to install the new sensor. A FlashPro modification file is provided with this sensor.   A must-have bolt on for the Civic Type R. 

    $390.00
    Hondata direct injection fuel pump  software unlock

    Hondata direct injection fuel pump software unlock

    Enables the FlashPro Manager to control non-stock high pressure fuel pump. You will receive a code to unlock the HPFP control for your FlashPro.     After purchase please email dealers@hondata.com with your order number and Hondata fuel system serial number.   *Unlock codes are single-use only. If you need to use it again, a new purchase is required.*

    $400.00
    Hondata FK8 Jailbreaker 2020 US Civic Type R

    Hondata FK8 Jailbreaker 2020 US Civic Type R

    This Jailbreaker temporarily bypasses the CAN gateway on the 2020-2021 US market Honda Civic Type R so that you can instant jailbreak the ECU. You do not need this product for the 2017-2019 US Honda Civic Type R or any other vehicle. You still need to purchase the instant jailbreak. The Jailbreaker device (not the instant jailbreak) can be used on as many vehicles are you like. Instructions Update FlashProManager to the latest beta version. Do not attempt to jailbreak the ECU if the ECU is in recovery mode.  In this case return the ECU to stock and verify it is working. Pull the left side of the lower dash free.  It is held in with spring clips and will come away without much force. Locate the stock CAN gateway. It is on the same wiring as the white and the blue connectors which plug into the lower dash. Unplug the stock CAN gateway and plug in the Jailbreaker. Using your FlashPro perform an instant jailbreak as described here. Unplug the Jailbreaker and plug back in the stock CAN gateway. Push the lower dash back into place. Drive the vehicle a short distance to clear any problem codes.    

    $75.00
    Hondata FlashPro Pins

    Hondata FlashPro Pins

    These pins are for Civic FlashPro owners who wish to add additional ECU inputs and outputs. FlashPro Manager currently supports wideband input on B29 and boost control solenoid output on connector B2. The package includes two large (top and bottom rows) and two small pins (center rows).

    $5.00
    Hondata Hoodie  - Laptop With Zipper

    Hondata Hoodie - Laptop With Zipper

    Get your Hondata hoodie!  50% cotton / 50% polyester with full-zip hood.  The front of the hoodie has the design on left chest. The back of the hoodie has the bigger Hondata logo. (Designs may vary.) *If we are out of stock on your specific size requested, we will contact you to notify you*

    $65.00
    Hondata Hoodie - Logo No Zipper - Black

    Hondata Hoodie - Logo No Zipper - Black

    Get your Hondata hoodie!  50% cotton / 50% polyester The front of the hoodie has the smaller Hondata logo (left side of chest). The back of the hoodie has the bigger Hondata logo. (Designs may vary.) *If we are out of stock on your specific size requested, we will contact you to notify you*

    $50.00
    Hondata Logo T-Shirt - Black

    Hondata Logo T-Shirt - Black

    Now you can wear the brand that's often hidden in binary. Our brand new shirt has a comfortable stylish fit that showcases a large Hondata Logo in front with a small logo on the upper back.Instagram: @hondata_inc TikTok: @hondatainc60% Combed Ring-Spun Cotton, 40% Polyester

    $25.00
    Hondata Logo T-Shirt - Blue

    Hondata Logo T-Shirt - Blue

    Now you can wear the brand that's often hidden in binary. Our brand new shirt has a comfortable stylish fit that showcases a large Hondata Logo in front with a small logo on the upper back.Instagram: @hondata_inc TikTok: @hondatainc60% Combed Ring-Spun Cotton, 40% Polyester

    $25.00
    Showing 1 to 20 of 35 (2 Pages)